|
1994 Honda Civic 1.5L No Start Ok guys, I have spark (good), fuel pressure, noid tested
inj. ok. Still no start. Here is my concern. I lined up the
timing marks on the crank pulley, as well as the cam
pulley, and they are fine. Also verified with a screwdriver
that #1 cyl was at top dead ce... |
View |
|
1999 Honda Accord 2.3L wipers The details are scetchy, but customer says wipers have a
mind of thier own. We are familiar with the speed change on
intermittant high when you go above 12 mph. She said this
morning on the way to the shop high would not work. Looking
at the wiring diagram, it... |
View |
|
2000 Honda CR-V 2.0L wheel bearings Fellow techs,sorry I thought I know Hondas well enough But
I need your help on this CRV,driving about 60 kph there is
a noticeable noise coming from the wheels.I use a
stethoscope to pinpoint noise and its coming from left
front and rear left wheel bearings so... |
View |
|
2003 Honda Accord 2.4L steering Hello all,
This vehicle came in with a interesting problem. While
going into any kind of body roll there was a large popping
or clicking noise heard from the suspension. I know that
the sway bar links can make this noise so I disconnected
them, took the vehic... |
View |
|
2002 Hyundai Sonata 2.4L Misfire, MIL Lamp on we thought timing belt was the main problem, however after
returning the car to the owner, the same problem occured
again with all codes returning but code p0340, we retested
and replaced spark plugs, flushed injection system and
throttle body, maf sensor. the... Trouble codes: P0300 (p0302-), P0302 (p0303-), P0303 (p0340-), P0340. |
View |
|
2007 Hyundai Accent 1.6L Surge the engine seems to have a lite miss on accel and at
cruise from 70 klometers down.Can feel alite viration on
the gas padal.also it seems a little sulggish when pulling
away. once it gets over 70 k's it works just fine.IT had a
knock sensor install at the Hyun... |
View |
|
2003 Kia Sedona 3.5L Airbag This van came in with the Airbag, Brake, and Battery lights
on found the Alt. overcharging and the I/C burned out
between the Brake and Battery lights, Replaced the Alt and
I/C but the airbag light is still on. I can not get into
the airbag module to read or c... |
View |
|
1995 Lexus LS 400 4.0L Shift Selection I'm not a transmission specialist by any means, I lack a
lot of critical knowledge in this area I admit. However
this particular customer has been a friend of the family
for years, and a dedicated customer other than while he was
out of town when the problem b... |
View |
|
2003 Mazda Tribute 3.0L door ajar lamp I unplugged every door jam and rear hatch connector. I
looked through alldata and cannot find a good schematic on
how the circuit works. I don't know if i need to loop a
wire to complete the circuit to shut the light off or if
unplugging the door connectors wi... |
View |
|
2004 Mazda 3 2.3L charging system Hey guys I have a 04 Mazda 3 in here that is over charging
at 16.04 volts. we replaced the alt.,the computer, and the
passenger junction box. The computer is seeing a 14.7
reading but the wire going to the compuer is reading 16.5
we have tried two different al... |
View |
|
1978 Nissan 280Z 2.8L Illumination We have this 280Z that has no dash illumination with the
headlights on. We no longer have any schematics for a
vehicle this old. I was wondering if someone could fax me a
wiring schematic for the interior and illumination
circuits. Thank in advance. The fax nu... |
View |
|
1997 Nissan Pickup 2.4L ign ckt fuse link blows once a week both times while backing up,
truck will stall because fuse link burns. fuse link is
white with black stripe goes direct to ign switch. at
switch black with white stripe (1g/pos 3) solder is melted
according to wiring diagrams follow... |
View |
|
1998 Nissan Pathfinder 3.3L Hazard Lights Hello Fellow Techs,
Thank you in advance for your help. I have a 98 Pathfinder-
No Hazzard Lights.. Turn signals operate perfectly...
Replaced the flasher & the hazzard switch.. The turn
signals stop working when the hazzard button is pushed-- I
believe this ... |
View |
|
1998 Nissan Frontier 2.4L MIL Lamp on Intermittently sets PO500 Speedo works fine Inspected
wiring seems ok. have alldata bulletin doesnt apply sets
code PO500 above 2000 rpm any info please reply Trouble codes: po500 (vss). |
View |
|
2002 Nissan Sentra 2.5L MIL Lamp on customer complaint is no throttle response and erratic
idle when started. the vehicle had previously been to
another shop and they replaced the throttle body for this
problem.he also mentioned they replaced the cam sensor
also. why this was done, i have no ide... Trouble codes: 507 (idle speed control), 605 (electronic control module). |
View |
|
2004 Nissan Altima 3.5L Poor Idle Quality, MIL Lamp on hey all,thanks in advance.have this nissan in here that had
been at local dealer for diagnosis.dealer rec timing chains
and guides for repair.vehicle brought to me.replaced all 3
timing chains and guides.vehicle has same problem.runs
rough at idle sets codes p... Trouble codes: p0021 (intake variable timing performance), p0300 (random cylinder misfire). |
View |
|
2000 Toyota Camry 2.2L Accessories I am trying to find the proceedure to reprogram a newly
replaced security alarm transmitter. There is some
confusion on this one. Looking at Toyotas bulletin for an
ID of the system I find that my transmitter is the only one
that is used on both the port insta... |
View |