|
|
1998 Honda Civic 1.6L MIL Lamp on
hell i have this honda that keeps turnig on the cel for
dtc p1106. alldata has no diag info or repair. it just says
reset ecm the run engine at 3000 rpm if dtc returns ecm is
bad, the baro sensor is in the ecm. has anyone run into
this problem anf would be hel... Trouble codes: P1106 (baro sensor range performance problem). |
View |
|
2003 Honda Accord 3.0L No Start, Poor Idle Quality, Hesitation, Cuts out, Stall, MIL Lamp on
Car was a tow in, customer complained about a no-start
situation. Had the computer on and pulled the codes up.
Thought it could possibly be the Map or throttle sensor, so
i had unplugged them and the car started. Then plugged the
sensors back and had NO Thrott... Trouble codes: p2122 (Throttle position low input), p2127 (TT low input), p0107 (Map sensor low input), p0117 (ECT sensor low), p2222 (Baro meter), p2627 (Pumping current). |
View |
|
2002 Hyundai Sonata 2.4L hard start
hey guys, well here we go. 02 hyundai sonata 2.4. customer
complains of intermittent hard start, ses light. scanned,
found p0171 lean code. fuel trims and o2 data looks fine,
no vaccum leaks to be found. fuel pressure ok. maf readings
seemed to be sluggish, so... Trouble codes: p0171 (lean bank one). |
View |
|
1997 Infiniti J30 3.0L Hesitation
Car came in with check engine light on,had 2 tps codes we
placed tps and adjusted. car ran fine check engine light
stayed off. car came back with complaint of hesitation at
take off and it does..i double checked tps,fuel pressure
and timing, all ok. now it hes... |
View |
|
2002 Infiniti I35 3.5L MIL Lamp on
greetings to all this car has two codes one for the evap
and the other for an 02 sensor.i smoked the evap system
twice and i do not see any leaks,how ever my smoke machine
can seal of the evap system to see if it will hold pressure
but when i do that the gauge... Trouble codes: PO1147 (02 sensor sensor 2 bank1 max voltage), PO14556 (small evap leak). |
View |
|
2003 Kia Sorento 3.5L Stall, Misfire, MIL Lamp on
vehicle stalls and will not re-start according to owner.
runs fine for me. anybody seen a similar scenario with
these codes. really suspect engine speed input (p0727).
anybody been down this road?? your experience and help is
greatly appreciated!!! Trouble codes: P0700 (trans contl), P0335 (crank pos sens a), P0306 (cyl 6 misfire), P0727 (engine speed input no signal). |
View |
|
2005 Kia Optima 2.7L electical
dash fire, does anyone have any wiring diagrams. on the
bottom of the fuse box looking towards the front there is a
black box (etacs) behind this on the back of the fuse box
left side very bottom white plug, brown wire, this is the
wire thats burnt.any one kno... |
View |
|
1993 Lexus GS 300 3.0L Specs.
Hello, I have a silly request: could someone e-mail me
please a few tightening specs. for this car? I need the
torque specs. (and sequence) for the head bolts, cam
sprockets, front crank pulley. Also wondering if I have to
use new head bolts and if there is an... |
View |
|
1995 Lexus LS 400 4.0L solinoid/tcm
this car is driving me crazy! six months ago had same
problem but also had tcc solinoid or valve problem, would
die after warmed up when coming to a stop. would have to
put in neutral before stopping and then kill the car and
restart to be able to put in gear ... |
View |
|
1999 Mazda Protege 1.6L MIL Lamp on
code p0171 on, replaced air flow meter and air boot. light
came on again 1 day later. we replaced air flow meter again
numbers still high. o2 switches good, but tends to hang on
the righ side even with high fule trim numbers. long term
camps out around 12-14 a... Trouble codes: p0171 (system lean). |
View |
|
2001 Mazda Protege 2.0L MIL Lamp on
Hello to all, this mazda intermittantly sets this po421
code. I replaced both o2s with mazda parts as the upstream
was slow to switch and have over 100k on them. cleared
codes road tested with passing results per [...] steps.
came back again with the same... Trouble codes: po421 (cat. warm up effiency below limit). |
View |
|
2001 Nissan Maxima 3.0L No Start
I have this Maxima that needs a new ECM, board is badly
burned. My question is if i aquire a used computer from a
same vehicle will the security system keep it from starting
and if so can it be re-programmed? |
View |
|
2001 Nissan Sentra 1.8L Poor Idle Quality, Surge, Stall
THIS VEHICLE HAS A STALLING AND LOPING SURGING PROBLEM.
STALLING IS NOT SO PREVALANT. VEHICLE HAS NO FAULT CODES
BUT DOES HAVE AN EXHAUST LEAK AT THE FRONT FLEX PIPE.THIS
VEHICLE HAS THIS CONDITION AT IDLE AND ON ACCELERATION.
WHILE WATCHING THE VALUES ON THE ... |
View |
|
2003 Nissan Frontier 3.3L No Start
Vehicle will not start. No spark, no fuel injector pulse,
no fuel pump relay signal from ECM. I checked all power and
ground feeds to the ECM and everything checked out good..
The engine light does not light KOEO. The light does light
if I ground terminal 18 o... |
View |
|
2003 Nissan Maxima 3.5L Poor Idle Quality
this car came in and had a p1121 code, and would not move
every other time you would crank it up. i replaced the
throttle body and car now runs but i am getting the code
p507 for a high idle and it is between 800 and 1000rpm. i
run the throttle relearn(without... Trouble codes: P1121 (throttle out of range), P507 (idle s too high). |
View |
|
2005 Nissan Pathfinder 4.0L steering wheel
hey everyone this one has me beat.It's my neighbour's
truck.occasionaly this suv will develop a severe wobble in
the steering wheel at about 100 km it will stay there until
the speed is dropped to under 60 at which point it will
stop and not come back if you b... |
View |
|
1994 Subaru Legacy 2.2L Surge
This Suburu Has what I would call a surge or recoil at
just off idle throttle. While cruising and letting off to
go around a corner with just ever so slight throttle it
will buck. Acts like a EGR problem, however I dont think
this car uses a EGR system. I can ... |
View |
|
2004 Suzuki Forenza 2.0L Turn signals
Customer decided to drop this off with me since he'd spent
too much money throwing parts at it. They have replaced the
hazard switch, t/s switch, and flasher relay. I seem to
have all my grounds and powers according to my alldata
diagram. Looks like it should ... |
View |
|
1996 Honda Civic 1.6L Hesitation, Surge
Hello to all,I'm going to call this one fixed.Thanks to everyone who took the time out of their schedules to give me some input.Most of the replies that I received had been something that I had to do when I replaced the cylinder head gasket.(ie.vac leaks at ga... |
17 |
|
2000 Hyundai Accent 1.5L All Electric
Hi guys thanks for all the great suggestions I received. I was not able to get the vehicle to a "No Start" condition. The customer stated that it has only happened after it rained. He opted to take the vehicle now and bring it back on a later date since it was... |
6 |
|
2002 Hyundai Santa Fe 2.7L Compressor Coil
Disassembled clutch and found clutch face cracked and bearing very noise, did not notice this when replaced coil, coil has been very hot, waiting on parts from dealer, this is a obvious problem but when get new parts install will check ohms, power, grounds , r... |
4 |
|
1998 Isuzu Hombre 4.3L Cuts out, Misfire
Thanks to all who replied. This vehicle is fixed. as many said the fuel pressure was to low. The owner was hesitant to replace the pump as it had been replace a year before. After replacement the vehicle ran great and owner is very happy.
Thanks again |
11 |
|
1996 Kia Sportage 2.0L Excessive Emissions, Hesitation, Cuts out
Well I received 7 posts on this one. The customer did not want us to go any further. He just wants to drive it for a little while longer. I did check pin voltages at the PCM and there were several that would drop out. I also found that when I put a battery... |
8 |
|
1993 Lexus SC 400 4.0L MIL Lamp on
I have sent the original ECU to be repaired. It came back with the same code and no communication for the data stream! Sent it back and am waiting patiently for its return. Thanks to all. Trouble codes: 71 (egr), 38 (trans code). |
3 |
|
1994 Mazda 626 2.0L Poor Idle Quality, Misfire, MIL Lamp on
Well, this was a wierd one. We dont know if it is fixed or not. After cleaning the mass airflow & reseting min. air idle it appears to be much better, or is just not acting up. The customer decided to pick up the car. Thanks for all the responses guys. Trouble codes: 172 (o2 fixed lean). |
4 |
|
1997 Mitsubishi 3000GT 3.0L Misfire
timing belt jumped 3 teeth some how making 1 coil not fire repaired by changing timing belt, crank and cam sensors |
3 |
|
2001 Nissan Maxima 3.0L MIL Lamp on
it was the M A F sensor. Thank you all for your contributions--they were very helpful and mostly everyone had the same diagnosis plus some other insights. Trouble codes: po171 (lean bank 1). |
9 |
|
1996 Toyota RAV4 2.0L MIL Lamp on
While all of the responses were appreciated, the fix turned out to be a short in the black/white ground wire for the vsv. We disconnected the computer harness and were able to wiggle the wiring harness under the plennum to show a short to ground. I do not kn... Trouble codes: P0401 (e.g.r. low flow). |
8 |
|
1998 Toyota Land Cruiser 4.7L MIL Lamp on
Thank you for the replies. As it turns out the new evap. canister we installed two monthes ago was bad. It would not hold pressure. Installed a new canister and the vehicle has been running for two weeks with no problem. Thank you to all who responded. Trouble codes: P0446 (evap vent solenoid problem). |
5 |
|
Prev
