|
1981 Honda Accord 1.8L alt/reg this car is an oldie but a goodie.very clean!car came in
with wire harness to alt melted.removed harness,cut wires
back 3 inches and eliminated harness plug.alt is wired
strait to engine harness.soldered all connections.installed
new volt reg from honda,a bosc... |
View |
|
2001 Honda Passport 3.2L MIL Lamp on customer came in to the shop with check engine lite after
scanning we realize that coded 1120 was present .. code
state accel pedal sensor fault. i replace the sensor but
the code is still present Trouble codes: p1120 (accel pedal position sensor circuit fault). |
View |
|
2005 Honda Civic 1.7L MIL Lamp on hi guys. i have this 2005 honda civic came to our shop
with service codes p0497 and p1456. i did the test on p0497
first and everything tested ok no vacuum or hoses
leak,canister shut valve tested ok,purge valve tested
ok,power and ground tested good. then i p... |
View |
|
1997 Hyundai Tiburon 1.8L no forward gears This car came to me with Reverse only. Customer told me its
on its first transmission. this is the first time i've seen
the car. when i pull the #9 fuse(TCU) 2nd gear only, will
work. Its got me baffled! The first Transmission im not
sure why it failed but the... |
View |
|
2000 Hyundai Sonata 2.5L Injector pulse, fuel pump Hi, I had this car delivered last week that would not
start. They drove it to the local Safeway and it would not
start when they came out. There are no codes, no power to
the injectors, the fuel pump is not working, blown fuses
for the ecu relay and ecu. I pul... |
View |
|
2001 Hyundai Santa Fe 2.7L noisy lifters Originally came in with misfire and noisey lifters. Found
low compression and misfire on #3 cyl. pulled rear valve
cover and found 10 out of 12 lifter collapsed. Replaced all
rear bank lifters and changed oil. Customer picked up and
after 1 week called and sai... |
View |
|
1996 Kia Sportage 2.0L Excessive Emissions, Hesitation, Cuts out I have this 96 Kia with no codes and it was idling rough
and would backfire out the intake and want to die when
accelerating. I found the MAF to be out of range so I
installed a new MAF and it idled better. It still will spit
and sputter and backfire out the i... |
View |
|
1995 Lexus LS 400 4.0L solinoid/tcm this car is driving me crazy! six months ago had same
problem but also had tcc solinoid or valve problem, would
die after warmed up when coming to a stop. would have to
put in neutral before stopping and then kill the car and
restart to be able to put in gear ... |
View |
|
1994 Mazda 626 2.0L Poor Idle Quality, Misfire, MIL Lamp on This car runs rough at idle & feels like going to stall
occas. We cannot get any data from our Snap on brick. O2
voltage buries under 100 mv. when acting up. Once car is
warmed up seems to go away/or is much better(more of an
open loop problem) - Mass airflow ... Trouble codes: 172 (o2 fixed lean). |
View |
|
1999 Mazda 323 1.5L Cuts out HI TEAM
tHIS IS A CURLY ONE. THE CAR HAS AN INTERMITTANT
SURGING,MISS FIRE AND CUTTING OUT PROBLEM. IT ONLY SEEMS TO
HAPPEN AFTER HIGH LOAD DRIVING. THE CAR IS ALSO VERY FLAT
IN PERFORMANCE AND MY GUT FEELING IS THAT IT IS RUNNING
LEAN UNDER HIGH LOAD. IT HAS... Trouble codes: P1345 (cam shaft position sensor). |
View |
|
1995 Mitsubishi Expo 2.4L Hesitation, MIL Lamp on car will reset both codes within 2-3 mins of clearing cam
signal looks good on scope and did not drop out when code
set tested fr pin on alternator and got .3 volts which
alldata says is out of spec. my question is has anyone seen
p1500 causing cam code? i did... Trouble codes: p0340 (p1500-), p1500. |
View |
|
1995 Nissan Pathfinder 3.0L No Start, Cuts out HI all. Thanks in advance for your help. I have a 1995
Nissan Pathfinder with a 3.0 Liter engine. Its stalling
intermittently when hot. After it stalls and you try to
restart, all power to dash cuts out. There are no dash
lights, and no crank. I was thinking t... |
View |
|
1986 Toyota Camry 2.0L Poor Idle Quality, No Idle Hi guys let me first say that I do not have that much
experience with Toyota's. This little Camry will not Idle.
I have checked the TPS and seems to be in specs on my
vantage. Also I was going to check the Resistance of the
ISC valve as per All data and I can'... |
View |